FlexGain PLEX - Page 57

User’s manual FlexGain Plex, V2
Version 1.3 57 from 99
PLEX2_01_FMM>STATUS
-------------------------------
FlexGain Plex2 interface status
-------------------------------
INTERFACE STATUS
-------------------------------
PCM1 ON
PCM2 OFF
PCM3 OFF
V35 OFF
Ethernet LINK DOWN
RS232 LISTEN
P1 LOCK
P2 LOCK
P3 LOCK
P4 LOCK
P5 LOCK
P6 LOCK
P7 LOCK
P8 LOCK
-------------------------------
PLEX2_01_FMM>
Табл. 12. Описание команды <STATUS>.
ON Normal operation of the interface;
OFF Interface is off;
IDLE Interface is in the idle state;
BUSY Interface is in the «Busy» state;
RING Interface is in the «Ring» state;
NOT CONNECT Daughter board is absent;
LOCK Port is blocked;
EDL Digital loop on the V.35 interface is set;
RDL Digital loop on the E1 port from the output of the transmitter to the input of the
receiver is set;
LDL Digital loop on the E1 port from the output to the input of the multiplexer cross-
connect matrix is set;
Link Down The Ethernet network is not connected to the ETHERNET port or the cort is
configured incorrectly.
Link Up The Ethernet network is connected to the correctly configured ETHERNET port.
<TIME> command.
The <TIME> command allows the user to set and display time.
Command syntax:
<TIME> [HH.MM.SS]