FlexGain PLEX - Page 67

User’s manual FlexGain Plex, V2
Version 1.3 67 from 99
To display the help information, enter <DEFAULT /H>
Example:
PLEX2_01_CM>DEFAULT
Default settings restored.
<DELETE> command.
The <DELETE> command deletes the TS mapping on the specified port and deletes
the cross-connected time slots from the cross-connect table.
The <DELETE> command without any parameters displays the context help.
Command syntax:
(<DELETE> [Px|V35]>)|
(<DELETE> <MUX> <PCM1|PCM2> <Band>)
where
PCM1, PCM2 are notations of Е1 streams.
Band is the range of time slots to be deleted from the cross-connect table.
Px is the number of the voice port;
V35 is the V35 interface.
The <DELETE> command with the MUX parameter deletes time slots cross-
connected by the <MUX> command from the cross-connect table.
Example:
PLEX2_01_CM>DELETE V35
PLEX2_01_CM>DELETE MUX PCM1 1 31
To display the help information, enter <DELETE /H>
<EVENT> command.
The <EVENT> command displays and clears the event log.
Command syntax:
<EVENT> <LOG|CLEAR>
where
LOG displays the event log;
CLEAR clears the event log.
To display the help information, enter <EVENT /H>.
Example: