FlexGain PLEX - Page 69

User’s manual FlexGain Plex, V2
Version 1.3 69 from 99
<MOVECAS> <PCM1|PCM2> <TS>
where
PCM1, PCM2 are notations of Е1 streams.
TS is the number of the time slot used for signaling (1…15, 17…31).
To display the help information, enter <MOVECAS /H>
Example:
PLEX2_01_CM>MOVECAS PCM1 5
PLEX2_01_CM>MOVECAS
CAS timeslot numbers:
PCM1: 05
PCM2: 16
PCM3: 16
<MUX> command.
The <MUX> command sets the duplex exchange of time slots of the PCM1 stream
with the time slots of the second PCM2 stream.
One command at a time allows the organization of one cross-connect or a group of
cross-connects.
Command syntax:
(<MUX> <PCM1> <TSx> <PCM2> <TSy>)|
(<MUX> <PCM1> <FTS> <LTS> <PCM2> <TSz>)
where
TSx, TSy, TSz are numbers of cross-connected time slots.
PCM1, PCM2 are notations of Е1 streams.
FTS is the first time slot of the cross-connect group.
LTS is the last time slot of the cross-connect group.
Example: cross-connect of two time slots.
PLEX2_01_CM>MUX PCM1 1 PCM2 10
PLEX2_01_CM>MUX PCM1 5 PCM2 31
PLEX2_01_CM>CONNECT
FlexGain Plex2 cross-connect map:
------------------------------------------------------------------
PCM1 : PCM2 : PCM3
------------------------------------------------------------------
TS TARGET TS TARGET :TS TARGET TS TARGET :TS TARGET TS TARGET
------------------------------------------------------------------
00 FAS 16 CAS :00 FAS 16 CAS :00 FAS 16 CAS
01 PCM2.10 17 NC :01 NC 17 NC :01 NC 17 NC
02 NC 18 NC :02 NC 18 NC :02 NC 18 NC
03 NC 19 NC :03 NC 19 NC :03 NC 19 NC
04 NC 20 NC :04 NC 20 NC :04 NC 20 NC
05 PCM2.31 21 NC :05 NC 21 NC :05 NC 21 NC