FlexGain PLEX - Page 70

User’s manual FlexGain Plex, V2
Version 1.3 70 from 99
06 NC 22 NC :06 NC 22 NC :06 NC 22 NC
07 NC 23 NC :07 NC 23 NC :07 NC 23 NC
08 NC 24 NC :08 NC 24 NC :08 NC 24 NC
09 NC 25 NC :09 NC 25 NC :09 NC 25 NC
10 NC 26 NC :10 PCM1.01 26 NC :10 NC 26 NC
11 NC 27 NC :11 NC 27 NC :11 NC 27 NC
12 NC 28 NC :12 NC 28 NC :12 NC 28 NC
13 NC 29 NC :13 NC 29 NC :13 NC 29 NC
14 NC 30 NC :14 NC 30 NC :14 NC 30 NC
15 NC 31 NC :15 NC 31 PCM1.05 :15 NC 31 NC
------------------------------------------------------------------
PLEX2_01_CM>
Example: cross-connect of a group of time slots.
PLEX2_01_CM>MUX PCM1 7 15 PCM2 1
PLEX2_01_CM>CONNECT
FlexGain Plex2 cross-connect map:
------------------------------------------------------------------
PCM1 : PCM2 : PCM3
------------------------------------------------------------------
TS TARGET TS TARGET :TS TARGET TS TARGET :TS TARGET TS TARGET
------------------------------------------------------------------
00 FAS 16 CAS :00 FAS 16 CAS :00 FAS 16 CAS
01 PCM2.10 17 NC :01 PCM1.07 17 NC :01 NC 17 NC
02 NC 18 NC :02 PCM1.08 18 NC :02 NC 18 NC
03 NC 19 NC :03 PCM1.09 19 NC :03 NC 19 NC
04 NC 20 NC :04 PCM1.10 20 NC :04 NC 20 NC
05 PCM2.31 21 NC :05 PCM1.11 21 NC :05 NC 21 NC
06 NC 22 NC :06 PCM1.12 22 NC :06 NC 22 NC
07 PCM2.01 23 NC :07 PCM1.13 23 NC :07 NC 23 NC
08 PCM2.02 24 NC :08 PCM1.14 24 NC :08 NC 24 NC
09 PCM2.03 25 NC :09 PCM1.15 25 NC :09 NC 25 NC
10 PCM2.04 26 NC :10 PCM1.01 26 NC :10 NC 26 NC
11 PCM2.05 27 NC :11 NC 27 NC :11 NC 27 NC
12 PCM2.06 28 NC :12 NC 28 NC :12 NC 28 NC
13 PCM2.07 29 NC :13 NC 29 NC :13 NC 29 NC
14 PCM2.08 30 NC :14 NC 30 NC :14 NC 30 NC
15 PCM2.09 31 NC :15 NC 31 PCM1.05 :15 NC 31 NC
------------------------------------------------------------------
PLEX2_01_CM>
<NAME> command.
The <NAME> command displays the device identifier at the top of the main menu.
Command syntax:
<NAME> [ID]
where
ID is the device ID.
Example:
PLEX2_01_CM>NAME PLEX2
New module name:PLEX2