FlexGain PLEX - Page 75

User’s manual FlexGain Plex, V2
Version 1.3 75 from 99
<SETCLOCK> command.
The <SETCLOCK> command sets the clock source. The following can be used as a
clock source:
• A clock recovered from the incoming E1 stream;
• Input of the external synchronization;
• Internal clock.
The <SETCLOCK> command without any parameters displays the current clock
source.
Command syntax:
<SETCLOCK> <PCM1|PCM2|EXT|INT>
where
EXT means external clock (available only for Sub-Rack and Mini-Rack devices). If
the external clock signal is lost, the FlexGain Plex, V2 device switches to the internal clock;
INT means internal clock.
PCM1, PCM2 are notations of Е1 streams.
To display the help information, enter <SETCLOCK /H>
Example:
PLEX2_01_CM>SETCLOCK INT
PLEX2_01_CM>SETCLOCK
Current synchronization source:Internal
<SIGNALING> command.
The <SIGNALING> command is only available in PCM30 or PCM30C modes. This
command is used to set the type of line signaling in the dedicated TS.
Command syntax:
<SIGNALING> <Px|ALL> <TRANSPARENT | MMX | DEFINITY I
MEGATERM|MEGATRAIN>
where
Px is the number of the voice port(P1, P2, …, P8);
TRANSPARENT sets ‘transparent’ signaling with the “a” bit of the signaling TS;
MMX sets signaling with “a” and “b” bit of the signaling TS;
DEFINITY sets signaling providing interaction between a PBX and a FlexGain-Plex,
V2 device (with a FG-Plex-4FXS daughter board) connected to it through the E1 channel;
MEGATERM sets signaling used for the multiplexer operation as a part of a
«MEGATRANS» data transmission system (terminal communication station);