A Word about Batteries
"Power" button + the "Left" button).
Screenshots are saved and may be accessed in "Mass Storage Device" (MSD) mode
and are stored in the "Screens" folder accessible through the
computer/device file browser.
Before making the call, navigate to this screen and either copy the information or per-
form a screen capture by briefly pressing the "Power" + "Left"button and pull up the
image (stored on the Mass Storage Device" to read the information there captured to
the representative.
This information will prove useful in the event that the FLIRdetection service depart-
ment must be contacted to assist with any concerns in the operation of the FLIR
identiFINDER R200.
Chapter two covers the details of the FLIR identiFINDER R200 operations such as the
display, the keys, its holster, the Web Server, and startup/shutdown.
The Field Operating Guide is presented in chapter three where items such as instrument checking, sur-
veys, locating the source and identifying it, and then communicating with a PC, sending the results to a
remote server and then switching the unit off.
Chapters 4 and 5 cover modes and alarms, and chapter 6 provides a complete run-down of the menus.
Chapter 6 covers how to connect to a local computer, and 7 details the use of a web interface.
Chapter 8 covers information regarding powering the R200 and the appenixes cover specification, cus-
tomer service, warranty information, cleaning and the like.
Check to see that the FLIR identiFINDER R200 is in the mode appropriate
to situational requirements. AutoMode may not provide results consistent
with those desired.
1-9 R200 3/10/2017__1:38 PM
To Next Page
Loading...
