FLIR identiFINDER R200 - Page 33

2.2.2 Basic Commands
Command Definition
Use this to access menus.
Identify Mode
This switches the display to show more details of the
identification.
This exits the identification mode.
Displays the spectra.
Expands (zooms) for focus on particular portion of
screen.
Use the "Skip" button to change the mode of
the navigation buttons (UP-DOWN, LEFT-RIGHT),
and to Exit a given menu. Used in setting parameters
to advance or detract digits, or to navigate scroll lists.
Severity
"Innocent" (the letter "i" inside a square), "Sus-
picious" (question mark in a triangle), and "Threat-
ening" (exlamation point on a stop sign shield).
These icons display in "Identify"mode in the results
("Record") window and are consistent with the nuc-
lide
settings defined in the Web Server section (see "Nuc-
lide List" on page84). The parameters for display of
these icons may be set for each nuclide by the user
in the Web Browser when connected to the R200.
Toggling
To toggle between the Dose Rate and Count Rate
Command Definitions(continued)
2-26 R200 3/10/2017__1:38 PM