Setup
5
5.1.9 Audio
The Audio tab allows you to enable / disable camera audio as well as choose the audio en-
coding type. The settings in this menu will affect both one-directional and bidirectional
audio for the camera.
Note
This setting is only available on cameras with a microphone. Check the technical specifications for your
camera.
To configure audio settings:
1. Check Enable under Main Stream, Sub Stream, or both to enable audio.
2. Under Encode Mode, select an encoding mode from PCM, G.711A and G.711Mu.
3. Click Save to save changes.
5.2 Network
5.2.1 TCP-IP
The TCP-IP menu allows you to configure the camera for DHCP or Static IP addressing.
To configure IP address settings:
1. Under Host Name, enter the Host Name for the camera up to 32 characters.
2. Under IP Version, select IPV4 or IPV6.
3. Under Mode, select Static or DHCP. If you select Static, configure the IP Address,
Subnet, Mask, Default Gateway, Preferred DNS Server, and Alternate DNS
Server.
4. Click Save to save changes.
#LX400038; r. 1.0/18537/18537; en-US
23
To Next Page
Loading...
Need help?
General
