FLIR IP Series User Manual

Setup
5
To reset PTZ defaults:
1. Under PTZ > Function, click Default.
2. Click Default.
CAUTION
Resetting to defaults will erase any custom PTZ functions you have created — this step cannot be
undone.
5.4 Event
5.4.1 Motion Detect
The Video Detect menu allows you to set up motion detection and recording.
Note
Recording functions require an FTP server or an on-board microSD card. Some camera models do not
support these recording features.
To set up motion detection settings:
1. Check Enable to enable motion detection.
#LX400038; r. 1.0/18537/18537; en-US
35

FLIR IP Series Specifications

General

Sensor Type	Uncooled microbolometer
Weather Resistance	Yes
Video Compression	H.264, MJPEG
Power	PoE (IEEE 802.3af)
Spectral Range	7.5 – 13 μm
Thermal Sensitivity	< 50 mK
Video Output	Ethernet
IP Rating	IP66
Resolution	320 × 240 pixels
Frame Rate	Up to 30 Hz (varies by model)