SolutionPossible reasonProblem
Focus the camera by
pressing and holding down
the A button for a few sec-
onds.
The target may be out of focus.The LCD/viewfinder dis-
plays an infrared image, but
it is blurry.
Change the ocular diopter
adjustment by rotating the
adjustment knob on the
bottom side of the
viewfinder.
The ocular diopter adjustment of the
viewfinder may be incorrect.
Focus the visual camera by
rotating the focus ring on
the visual camera.
The target may be out of focus.The LCD/viewfinder dis-
plays a visual image, but it
is blurry.
Change the illumination of
the LCD.
The illumination of the LCD may have acci-
dentally been set to too low a value.
The LCD/viewfinder dis-
plays an image, but it is of
low illumination.
Verify that the video cable
connector is properly insert-
ed.
The video cable connector may not be
properly inserted into the video connector
on the camera.
When connecting the in-
frared camera to an exter-
nal video monitor, no image
appears.
Verify that the video cable
connector is properly insert-
ed.
The video cable connector may not be
properly inserted into the video connector
on the external monitor.
Change the video format.The camera may have accidentally been
set to PAL video format, while the external
video monitor will only display NTSC video
format, and vice versa.
To be able to save more
images, download the im-
ages to your computer us-
ing ThermaCAM™ Quick-
View.
The internal flash memory may be full.It is not possible to store
any more images in the
camera.
To be able to save more
images, move the images
from the CompactFlash
card by downloading them
to your computer using
ThermaCAM™ QuickView,
or replace the card with an
empty card.
The CompactFlash card may be full.
Change the date & time.The camera may have accidentally been
set to the wrong date & time.
The LCD/viewfinder does
not display the correct date
& time.
15
96 Publ. No. 1557978 Rev. a155 – ENGLISH (EN) – February 6, 2006
15 – Troubleshooting
To Next Page
Loading...
Need help?
General
