FLIR ThermaCam P25 User Manual

The counter will be reset when exceeding 9999,
or when you point to Factory default on the Setup
menu and press the joystick.
Comment
Figure 10.27 Naming based on current date – explanations
Typical syntax: IR_YYMMDD_nnn.jpg
■
IR = infrared imageIR
Current date. The format depends on your settings
in the Local settings dialog box.
YYMMDD
Counter within directorynnn
IR_020909_001.jpgExample
The counter will be reset every day.Comment
Figure 10.28 Naming based on current directory – explanations
Typical syntax: IR_DIRE_nnn.jpg
■
IR = infrared imageIR
The first four letters in the directory nameDIRE
Counter within directorynnn
IR_ COMP_003.jpgExample
10.2.5.3 Power
10392703;a3
Figure 10.29 Power Setup dialog box
Figure 10.30 Explanations of the Power Setup dialog box
CommentsValueLabel
Move the joystick left/right to specify the time after
which the camera will be switched off if it is not
used.
■
None
■
10 min
Auto power off
Move the joystick left/right to specify the time after
which the display will be switched off if it is not
used.
■
None
■
30 sec
■
60 sec
Display power off
Move the joystick left/right to specify the level of
background illumination of the LCD.
■
Low
■
Medium
■
High
LCD illumination
10
Publ. No. 1557978 Rev. a155 – ENGLISH (EN) – February 6, 2006 79
10 – Camera program

FLIR ThermaCam P25 Specifications

General

Brand	FLIR
Model	ThermaCam P25
Category	Thermal cameras
Language	English