ActionStep
Do one of the following:
■
Press and hold down the S button for a few seconds to save the image
■
Point to Save on the File menu and press the joystick
3
For more information about saving images, see section 10.2.2.2 – Save on page 69.
8.3 Working with measurements
8.3.1 Creating & changing an isotherm
ActionStep
Press the joystick to display the horizontal menu bar.1
Point to Add isotherm on the Analysis menu and press the joystick. An isotherm
will now be added to your image. The isotherm levels will be displayed in the result
table in the top right corner of the screen.
You are now in edit mode and can change the isotherm levels by moving the joy-
stick up/down. To leave the edit mode, press the C button twice. You can also
leave the edit mode by holding down the joystick for a few seconds, which will
display a shortcut menu.
2
For more information about creating & changing an isotherm, see section 10.2.3.3 –
Add isotherm on page 71.
8
44 Publ. No. 1557978 Rev. a155 – ENGLISH (EN) – February 6, 2006
8 – Tutorials
To Next Page
Loading...
Need help?
General
