Power Recorder
Charging the PDA Battery
9
Charging the PDA Battery
Your PDA is shipped with a discharged or partially charged, rechargeable
battery. You should fully charge the battery before setting up the device, and
recharge it regularly. Refer to your PDA user’s guide for detailed information
about the battery.
Caution
Do not leave important data on the PDA. If the battery
discharges completely, you will lose all data not stored in
File Store (ROM). Discharging the battery completely is
similar to performing a hard reset. Refer to the PDA Users
Manual for more information.
Installing the Software
This section describes how to install Fluke Power View software on the PDA
and Fluke Power Analyze software on your PC. Keep your product CD in case
you need to reinstall this software in the future. You should periodically check
the Fluke website: www.fluke.com
to see if any 1750 firmware or application
software updates are available for download. Fluke encourages you to register
the Recorder. After your Recorder has been registered, you will receive email
notifications of firmware and software update availability.
Installing Power View on the PDA
1. Insert the CD that ships with your PDA. Follow the on-screen instructions
to install the ActiveSync software for Windows XP (or Mobile Device
Center for Windows Vista and Windows 7) that allows your PC to
communicate with the PDA.
2. Connect the PDA to your PC with the USB lead and establish
communication between the PDA and your PC. Keep your product CD in
case you need to reinstall this software in the future.
3. Insert the CD that ships with your Recorder in the CD-ROM drive on your
PC.
4. A window appears that lists options on the CD. If the install software
window does not automatically appear, do the following:
To Next Page
Loading...
Need help?
General
