Fluke 45 - Page 182

45
Service Manual
2
display assembly troubleshooting, 5-17
display controller with FIP, 2-22
—E—
editing the prompt for different calibration
points, 4-14
eerom, 2-19
entering calibration mode, 4-8
error codes, 5-4
exiting calibration mode, 4-9
—F—
failure to enter remote, 8-11
failure to generate a service request (srq), 8-12
failure to generate an end or identify (eoi), 8-12
failure to handshake on ieee-488 bus, 8-11
failure to receive multiple character
commands, 8-12
failure to select ieee-488 option, 8-10
failure to transmit query responses, 8-12
frequency, 2-15
frequency calibration (computer interface), 4-20
frequency calibration (front panel), 4-13
front panel calibration, 4-7
front panel switches, 2-20
functional block description, 2-3, 7-3, 8-3
fuse test and replacement, 3-4
—G—
general maintenance, 7-6, 8-8
general maintenance information, 3-3
general operability, 7-9
general troubleshooting procedures, 5-10
—H—
how to contact fluke, 6-4
how to obtain parts, 6-3
—I—
ieee-488 controller, 8-4
ieee-488 interface, 4-16
ieee-488 option (-05), 2-5
ieee-488 option connections, 2-20
ieee-488 transceivers/connector, 8-5
input protection, 2-10
input protection circuit, 2-3
input signal conditioning, 2-3, 2-10
install miscellaneous chassis components, 3-10
install the analog measurement processor
shields, 3-11
install the battery option, 3-11
install the front panel assembly, 3-15
install the handle and mounting brackets, 3-15
install the ieee-488 option, 3-12
install the main pca, 3-11
install the meter case, 3-15
install the rms pca, 3-11
installation, 7-7
installing the ieee-488 option, 8-9
inverter, 2-7, 5-12
isolation circuits, 8-4
—L—
line fuse, 3-4
list of replaceable parts, 7-14, 8-12
low battery disconnect, 7-5
low battery indicator detector, 7-5
low battery indicator detector and low battery
disconnect test, 7-10
—M—
main assembly connector, 2-20
main assembly connectors, 8-3
manual status information, 6-4
microprocessor, 2-19
—N—
newer instruments, 6-4
—O—
ohms, 2-12
ohms calibration (computer interface), 4-19
ohms calibration (front panel), 4-11
ohms troubleshooting, 5-14
operating instructions, 1-3
options and accessories, 1-3
organization of the service manual, 1-4
other circuits, 7-6
—P—
performance testing, 7-9, 8-9
performance tests, 4-4
power requirements, 3-3
power supply, 2-3
power supply circuit description, 2-5
power supply troubleshooting, 5-10
power-up problems, 8-10
—R—
ram, 2-20
raw dc supply, 2-6, 5-10
relays, 2-11
removal, 7-6
remove handle and mounting brackets, 3-7