Fluke 9100 - Page 105

Section 4: Using the Model 9100: DC Voltage Function 4.3-11
Final Width = 215mm
4.3.6 DC Voltage Routines for Calibrating UUTs
4.3.6.1 Interconnections
The general connection scheme for UUT calibration is illustrated in Fig. 4.3.2.
For UUTs without safety banana sockets, use appropriate adaptors.
Fig. 4.3.2 Interconnections for DC Voltage UUT Calibration
(Leads which are not shown are not connected)
10A mA COM V-
A
A
A
A
A
Cap
+
-
I+mAI+ 20ALI-
sLsHH
WhiYellBlkBlkRedRed
Adaptor Parking Holes
Work Mat
UUT
AA
AA
AA
Thermo
Couple
+
-