Fluke 9100 - 5.5 Procedure Mode - 1 Year Verification & ISO9000 Verify Procedures

Section 5: Using the Model 9100: Procedure Mode 5.5-1
Final Width = 215mm
5.5 Procedure Mode — '1 Year Verification' &
'ISO9000 Verify' Procedures
5.5.1 Introduction
Sub-section 5.5 extends the Procedure mode access guide of sub-section 5.3, to describe
the use of the '1 Year Verification' Procedure and its variant 'ISO9000 Verify'. The
following topics are covered:
5.5.1.1 'ISO9000 Verify' Procedure.
5.5.2 '1 Year Verification' or 'ISO9000 Verify' Procedure Selection.
5.5.2.1 Procedure Menu Screen for the Subject UUT Model.
5.5.2.2 Selection of '1 Year Verification' or 'ISO9000 Verify'.
5.5.3 General Sequence.
5.5.3.1 'OPERATOR PROMPT'.
5.5.3.2 'READ — SLEW SOURCE'.
5.5.3.3 High Voltage Warning.
5.5.3.4 'OK' / 'FAIL' Screen Keys.
5.5.3.5 'ENABLE CURSORS' Key.
5.5.3.6 'REPEAT PREV.' Key.
5.5.3.7 'ABORT' Key and End of Procedure.
5.5.4 Output Slewing.
5.5.4.1 Fine Slewing Adjustments.
5.5.4.2 Coarse Slewing Adjustments.
5.5.1.1 'ISO9000 Verify' Procedure
The mechanics of using the 'ISO9000 Verify' procedure are virtually identical with those
for '1 Year Verification'. Except for initial selection of the procedure, the only differences
are in the number and range of test points to be verified. These will become evident while
using the programmed procedure cards, and need no further explanation here.
When reading this sub-section for the 'ISO9000 Verify' procedure, merely substitute
'ISO9000 Verify' for '1 Year Verification'.