Fluke 9100 - Page 129

Section 4: Using the Model 9100: DC Current Function 4.5-3
Final Width = 215mm
4.5.3.1 Bottom Screen Keys
A Selects DC Current Function when AC Current Function is active.
A Selects AC Current Function when DC Current Function is active.
SELECT Permits Connection of output currents up to 1A, via the guarded
OUTPUT 'D-type' socket, instead of the main terminals, on the front panel.
Also Permits Connection of output currents via the 10- and 50-turn
coils (Option 200). Refer to paras 4.5.6.
∆ Accesses the 'Percentage Deviation' and 'DC Current Offset' displays
to add to the screen presentation. Refer to paras 4.5.3.3 and 4.5.4.1.
4.5.3.2 Right Side Screen Keys
A. Digit Edit Facility Keys operate on the value marked by the cursor.
X 10 Multiplies the marked value by ten.
÷ 10 Divides the marked value by ten.
± Reverses the polarity of the marked value.
ZERO Sets the marked value to zero.
B. Direct Edit Facility Right side screen keys operate on the value in the edit box,
and acting in place of the ↵ key, exit from Direct Edit back
to Digit Edit; then set the value as evaluated in the box.
i. Output Value and Offset Value
µA Evaluates the number in the box in Microamps.
mA Evaluates the number in the box in Milliamps.
A Evaluates the number in the box in Amps.
ii. Deviation Value
% Evaluates the number in the box in Percentage Deviation.
The Deviation value is limited to ±10% of the Output value.
Output and Offset values are set into the same resolution. All values are set into the
highest resolution available to their magnitude.
4.5.3 Screen Keys