Fluke 9100 - Page 128

4.5-2 Section 4: Using the Model 9100: DC Current Function
Final Width = 215mm
TODAYS DATE TIME
4.5.2 Selection of DC Current Function
(Manual Mode selected)
4.5.2.1 'A' Key
Current is selected by pressing the
'A' key at the right of the 'CALIBRATION SYSTEM'
panel.
4.5.2.2 Default Settings
At power-on the system defaults to DC Voltage function. Each time the
'A' key is pressed,
the system defaults into DC Current function.
If AC Current is already active, then the DC Current menu screen is opened by pressing
the
A screen key on the bottom row.
Whenever the DC Current menu screen is opened, except on recovery from a standby
period, it will appear with the following default settings:
x
∆
÷
A
A
A
ZERO
+
.
A
±
SELECT
OUTPUT