Fluke 9100 - Page 204

4.10-2 Section 4: Using the Model 9100: Mark/Period Function
Final Width = 215mm
4.10.2 Selection of Mark/Period Function
(Manual Mode selected)
4.10.2.1 'Hz' Key
Pressing the
'Hz' key at the right of the 'CALIBRATION SYSTEM' panel selects the
Frequency Function.
4.10.2.2 Default Settings
At power-on the system defaults into DC Voltage function. Each time the
Hz key is
pressed, the system defaults into Frequency function.
When Frequency or % Duty is active, then the Mark/Period menu screen is opened by
pressing the
screen key on the bottom row.
Whenever the
menu screen is opened, except on recovery from a standby period,
it will appear with the following default settings:
TODAYS DATE TIME
x
÷
.
ms
Hz
+
5.
V
.
V
.
ms
% DUTY
INVERT