DANGER
HIGH VOLTAGE
!
When using insulation testers, potentially lethal voltages
are produced. It is essential to take extreme care to
avoid the risk of electric shock.
THIS CAN KILL !
In particular!
1.Always ensure the tester is turned OFF before
connecting or disconnecting test leads.
2.Always use test leads which are in good condition, fully
insulated and have a suitably high insulation voltage
capability (the Model 9105 lead mat is suitable).
3.Do not touch the connections during any part of the test.
4.Never get the tester or the Model 9100 wet or near to
sources of water.
5.Never operate the unit in damp conditions or in very
high relative humidity.
6.Always turn the tester OFF immediately after
completing each test.
THIS INSTRUMENT IS CAPABLE OF DELIVERING
A LETHAL ELECTRIC SHOCK !
!
4.18-2 Section 4: Using the Model 9100: Insulation/Continuity Function (Option 135)
To Next Page
Loading...
