Section 3: Model 9100 Controls: Modes of Operation 3-13
Final Width = 215mm
TODAYS DATE TIME
TODAYS DATE TIME
Procedure Mode User List
1. A list of users is presented on the
opening menu screen of Procedure
mode, where the user's name can be
selected to appear on the certificate.
New names can be added to the
screen at the same time.
2. Names cannot be removed from the
list without knowing the Config
mode password, which must be used
to access the 'Clear user list' facility.
3.3.2.8 'CLEAR USER
LIST'
1. For access to allow the Procedure
mode user list to be cleared, press
the CLEAR USER LIST screen
key on the 'Present Settings' screen
Configuration
Press OK to clear the list
C F BARNES
F J BLOGGS
J K FLIPFLOP
OK
2. The 'CLEAR USER LIST' screen
key on the 'Present Settings' menu
transfers to the confirmation screen
3. OK removes all names from the
list.
4. EXIT returns to the 'Present
Settings menu screen.
Configuration
Present Settings:
Language English
Power-up mode Manual
Bus Address 1
Printer NONE
Results Card Disabled
Safety Voltage
.
V
Border Line
7
.
%
Scope option Option 600
Crystal option High acc
Ser. No. XXXXXX Rev. XXX
VOLTAGE
LIMIT
DATE
TIME
BORDER
LINE
SELECT
LANG
MORE
POWER
UP MODE
BUS
ADDRESS
RESULTS
CARD
PRINTER
CLEAR
USER
LIST
EXIT
To Next Page
Loading...
