You can set the temperature
between 16ºC and 28ºC in steps of
0.5ºC. In position LO (below 16ºC)
the system will switch to permanent
cooling, in HI (above 28ºC) to
permanent heating, and not regulate
a stable temperature.
Mono mode
In mono mode, the temperature
settings for both the driver’s and
passenger’s side are linked. If you
adjust the temperature using the
rotary control on the driver’s side, the
settings will be adjusted to the same
setting on the passenger’s side. In
mono mode, MONO appears in the
display.
To switch mono mode off
Select a temperature for the
passenger’s side with the rotary
control on the passenger’s side.
Mono mode will switch off and
MONO disappears from the display.
The temperature for the driver’ s side
will remain unchanged. You can now
adjust the driver and passenger side
temperatures independently of each
another. The temperature settings
for each side are shown in the
display. You can set a temperature
difference of up to 4ºC.
Note:
If you set a temperature of
greater than 4°C, the temperature
on the other side will be adjusted so
that the difference remains 4°C.
Note:
If you set one of the sides to
HI or LO, both sides will be set to HI
or LO.
To switch mono mode back
on
To switch mono mode back on,
press the MONO button. MONO
reappears in the display and the
passenger’s side temperature will be
adjusted to the driver’s side
temperature.
Blower
Use the buttons to adjust the blower
speed.
The blower setting is indicated in the
display.
To return to auto mode, press the
AUTO button.
Air distribution
To adjust air distribution, press the
desired button. Any combination of
settings can be selected
simultaneously.
112
Climate control
To Next Page
Loading...
Need help?
General
