WARNING
Do not operate the washer for
more than 10 seconds at a time,
and never when the reservoir is
empty.
Note:
On some models, to prevent
the washer fluid reservoir from
becoming empty too quickly, the
headlamp washer will not be
activated with every press of the
button. For a period of ten minutes
after activation, the washer will only
be activated again with every fourth
press of the button.
The headlamp washers operate
when the exterior lights are switched
on and the windscreen washer is
used. The system is supplied from
the washer fluid reservoir.
CHECKING THE WIPER
BLADES
Run the tip of your fingers over the
edge of the blade to check for
roughness.
Clean the wiper blade lips with water
applied with a soft sponge.
CHANGING THE WIPER
BLADES
Windscreen wiper blades
Lift the wiper arm. Position the wiper
blade at a right angle to the wiper
arm. Remove the blade from the arm
and replace it.
Rear window wiper blades
Lift the wiper arm and position the
wiper blade at a right angle to the
wiper arm. To remove, press the
retaining clip, disengage the wiper
blade and pull it off the arm in the
opposite direction.
63
Wipers and washers
To Next Page
Loading...
Need help?
General
