•
Press any button on a new
remote control. A tone will sound
as confirmation. Repeat this last
step for all your remote controls,
including your original. Do not
remove the key from the ignition
when pressing the button on this
remote control.
•
Switch the ignition back on
(position II) or wait for ten
seconds without programming
another remote control to end the
key programming. Only the
remote controls which you have
just programmed are now able to
lock and unlock the vehicle.
Reprogramming the
unlocking function
You can change the unlocking
function so that pressing the unlock
button once deactivates the central
locking or double locking, disarms
the anti-theft alarm system and
unlocks only the driver’s door.
Pressing the unlock button twice
within three seconds also unlocks the
passengers’ doors.
In order to re-programme the
function, press and hold the unlock
and lock buttons simultaneously for
at least four seconds with the ignition
switched off. The direction indicators
will flash twice to indicate that the
unlocking function has been
successfully re-programmed.
Pressing and holding both buttons
simultaneously for at least four
seconds again will change the
function back.
CHANGING THE REMOTE
CONTROL BATTERY
If the range of the transmitter in the
remote control decreases gradually,
the battery (type 3V CR 2032) should
be replaced.
Remote control type 1
First, press the button to release the
key blade.
Passive key
Remove the spare key.
36
Keys and remote controls
To Next Page
Loading...
Need help?
General
