In order to remove the seats from the
retaining bar on the floor, the seat
should be held at an angle of
approximately 45 degrees to the
floor.
Lift the seats out.
Installing the seats
WARNINGS
Make sure that no objects are
located in the storage
compartments under the rear seats
which could get damaged when the
seats are folded down.
To avoid injury, take care when
folding the seats down.
Make sure that the locking hole
on the floor is clear of sand, rock
or any objects which may prevent
the seat from locking.
Ensure that both locking claws are
rotated to the open position.
To reinstall the seats, lower the seat
onto the retaining bar on the floor. In
order to do so, the seat should be
held at an angle of approximately 45
degrees to the floor.
Before folding the seats back down,
pull the lower bar on the rear of the
seat and check that the latches are
in the delatched (extended) position.
Push the seat back down until it
engages.
131
Seats
To Next Page
Loading...
Need help?
General
