WARNING
The vehicle does not lock itself
automatically. If no locking
button is pressed, the vehicle will
remain unlocked.
Note:
Before leaving the vehicle,
ensure that the ignition switch is
pulled out. See Ignition switch
(page 141).
Note:
A valid passive key must be
located within the detection range of
the respective door. If locking from
the tailgate, the passive key must be
within the tailgate detection range.
Note:
Once activated, the vehicle
will remain locked for approximately
three seconds, even if the passive
key is within the detection range
during this delay period. This is to
allow you to pull a door handle and
check if the vehicle is locked. When
the delay period is over, the doors
can be opened again, provided the
passive key is within the respective
detection range. The delay period
can be set to zero by an expert.
Note:
If a passive key is left inside
the vehicle PASSIVE KEY LEFT
INSIDE appears in the information
display. Remove the passive key
from the vehicle interior. All passive
keys left inside the vehicle when it is
locked will be disabled.
To activate central locking and arm
the alarm:
•
Press the locking button on one
of the front doors or the tailgate
once.
•
On vehicles without double
locking, the direction indicators
will flash twice as confirmation.
To activate double locking, to arm
the alarm and the interior sensors:
•
Press the locking button on one
of the front doors or the tailgate
twice within three seconds.
•
The direction indicators will flash
twice as confirmation.
Deactivating the key free
function
The key free function can be
deactivated using the information
display. See Information displays
(page 96).
Once it is deactivated:
•
the vehicle can only be locked
and unlocked using the spare key
in the lock cylinder on the driver’ s
door or using the buttons on the
passive key.
•
the engine can only be started
with the spare key.
49
Locks
To Next Page
Loading...
Need help?
General
