Bottle holderE
Pressure gaugeF
Power plug with cableG
Compressor switchH
LabelI
Bottle lidJ
Sealant bottleK
1. Open the lid of the tyre repair kit.
2.
Peel off the label I showing the
maximum permissible speed of
80 km/h (50 mph) from the casing
and attach it to the instrument
panel in the driver’s field of view.
Make sure the label does not
obscure anything important.
3.
Take the hose C and the power
plug with cable G out of the kit.
4.
Unscrew the orange cap D and
the bottle lid J.
5.
Screw the sealant bottle K
clockwise into the bottle holder E
fully tight.
6. Remove the valve cap from the
damaged tyre.
7.
Detach the protective cap A from
the hose C and screw the hose
C firmly onto the valve of the
damaged tyre.
8. Make sure that the compressor
switch H is in position 0.
9.
Insert the power plug G into the
cigar lighter socket or auxiliary
power socket. See Cigar
lighter (page 134). See Auxiliary
power sockets (page 134).
10. Start the engine.
11.
Move the compressor switch H
to position 1.
12. Inflate the tyre for no longer than
seven minutes to an inflation
pressure of minimum 1.8 bar
(26 psi) and a maximum of
3.5 bar (51 psi). Move the
compressor switch H to position
0 and check the current tyre
pressure with pressure gauge
F.
13.
Remove the power plug G from
the cigar lighter socket or
auxiliary power socket.
14.
Quickly unscrew the hose C
from the tyre valve and replace
the protective cap A. Fasten the
valve cap again.
15.
Leave the sealant bottle K in the
bottle holder E.
16. Make sure the kit, the bottle lid
and the orange cap are stored
safely, but still easily accessible
in the vehicle. The kit will be
required again when you check
the tyre pressure.
221
Wheels and tyres
To Next Page
Loading...
Need help?
General
