Foscam CGI - Page 127

Foscam IPCamera CGI User Guide
Copyright@ Shenzhen Foscam Intelligent Technology Limited
127
linkage
Motion alarm linkage
( bit7 | bit6 | bit5 | bit4
bit3 | bit2 | bit1 | bit0 )
bit0:Ring
bit1:Send mail
bit2:Snap picture
bit3:Record
bit4:IO out
bit5:Snap to cloud
bit6:Record to cloud
bit7:Push message to
the phone
snapInterval
The interval time to snap picture again
sensitivity
Motion detect sensitivity
0 : Low
1: Normal
2: High
3: Lower
4: Lowest
triggerInterval
The time of which motion detect alaram can trigger again
when a motion detection has happened.P.s.The true value
of triggerInterval time is the value of the cgi get add 5s.
isMovAlarmEnabl
e
Is enable motion alarm detect
isPirAlarmEnable
Is enable Passive Infrared alarm detect
scheduleN
The motion alaram schedule of one week,
N = 0(Monday) ~6(Sunday)
For detail, see *1 bellow
Area(N)N(1-3)
x
Abscissa value of the detected area’s topleft
point
y
Vertical value of the detected area’s topleft point
width
The width of the detected area
height
The height of the detected area
sensitivit
y
Motion detect sensitivity
valid
Whether the area is valid
0:invalid
1:valid
Note
·The min unit of schedule is half an hour, scheduleN value range
1-2
N
(N[0-48])
.areaN value
1-2
N
(N[0-10])
Example
/cgi-bin/CGIProxy.fcgi?cmd=getMotionDetectConfig1&usr=admin&pwd=