Foscam CGI - Setioalarmconfig; Getioalarmconfig

Foscam IPCamera CGI User Guide
Copyright@ Shenzhen Foscam Intelligent Technology Limited
37
setIOAlarmConfig
Function
Set IO alarm config
privilege
admin
Usage
/cgi-bin/CGIProxy.fcgi?cmd=setIOAlarmConfig
Param
isEnable
Enable state
linkage
IO alarm linkage
bit0:Ring
bit1:Send mail
bit2:Snap picture
bit3:Record
alarmLevel
Alarm level,0-Low,1-high,trigger alarm
snapInterval
Interval for snap picture
triggerInterval
Interval for trigger alarm again,P.s.The true value of
triggerInterval time is the value of the cgi set add 5s.
scheduleN
N(0-6), alarm schedule
Return
Set result(0-success,-1-error)
Note
Example
/cgi-bin/CGIProxy.fcgi?cmd=setIOAlarmConfig&usr=admin&pwd=&isEnable=1
&linkage=16&snapInterval=2&alarmLevel=1&triggerInterval=5&schedule0=102
4&schedule1=1024&schedule2=1024&schedule3=1024&schedule4=1024&sch
edule5=1024&schedule6=1024
getIOAlarmConfig
Function
Get IO alarm config
privilege
admin
Usage
/cgi-bin/CGIProxy.fcgi?cmd=getIOAlarmConfig
Param
None
Return
isEnable
Enable state
linkage
IO alarm linkage
bit0:Ring
bit1:Send mail
bit2:Snap picture
bit3:Record
alarmLevel
Alarm level
snapInterval
Interval for snap picture
triggerInterval
Interval for trigger alarm again ， P.s.The true value of
triggerInterval time is the value of the cgi get add 5s.