Foscam CGI - Setmotiondetectconfig

Foscam IPCamera CGI User Guide
Copyright@ Shenzhen Foscam Intelligent Technology Limited
27
sensitivity
1: Normal
2: High
3: Lower
4: Lowest
triggerInterval
The time of which motion detect alaram can
trigger again when a motion detection has
happened.P.s.The true value of triggerInterval
time is the value of the cgi get add 5s.
isMovAlarmEnable
Is enable motion alarm detect
isPirAlarmEnable
Is enable Passive Infrared alarm detect
scheduleN
The motion alaram schedule of one week,
N = 0(Monday) ~6(Sunday)
For detail, see *1 bellow
areaN
The area info of row N
For detail, see *2 bellow
Note
·Video region is divided into 10*10 sub areasideo region is divided into 10*10
sub areas
·The min unit of schedule is half an hour, scheduleN value range
1-2
N
(N[0-48])
.areaN value
1-2
N
(N[0-10])
Example
/cgi-bin/CGIProxy.fcgi?cmd=getMotionDetectConfig&usr=admin&pwd=
setMotionDetectConfig
Function
Set motion detect config
privilege
admin
Usage
/cgi-bin/CGIProxy.fcgi?cmd=setMotionDetectConfig
Param
isEnable
Is enable motion detect alarm
linkage
Motion alarm linkage
( bit3 | bit2 | bit1 | bit0 )
bit0:Ring
bit1:Send mail
bit2:Snap picture
bit3:Record
snapInterval
The interval time to snap picture again
sensitivity
Motion detect
sensitivity
0 : Low
1: Normal
2: High
3: Lower
4: Lowest