Foscam CGI - Setmotiondetectconfig1

Foscam IPCamera CGI User Guide
Copyright@ Shenzhen Foscam Intelligent Technology Limited
128
setMotionDetectConfig1
Function
Set motion detect config
privilege
admin
Usage
/cgi-bin/CGIProxy.fcgi?cmd=setMotionDetectConfig
Param
isEnable
Is enable motion detect alarm
linkage
Motion alarm
linkage
( bit7 | bit6 | bit5 |
bit4
bit3 | bit2 | bit1 |
bit0 )
bit0:Ring
bit1:Send mail
bit2:Snap picture
bit3:Record
bit4:IO out
bit5:Snap to cloud
bit6:Record to cloud
bit7:Push message to the phone
snapInterval
The interval time to snap picture again
triggerInterval
The time of which motion detect alaram can trigger
again when a motion detection has happened.P.s.The
true value of triggerInterval time is the value of the
cgi set add 5s.
isMovAlarmEnable
0
Disable
1
Enable
isPirAlarmEnable
0
Disable
1
Enable
schedule
N
The motion alaram schedule of one week,
N = 0(Monday) ~6(Sunday)
For detail, see *1 bellow
Area(N)
N(1-3)
x
Abscissa value of the detected area’s topleft point
y
Vertical value of the detected area’s topleft point
width
The width of the detected area
Range[0,10000]
height
The height of the detected area
Range[0,10000]
sensitivity
Motion detect sensitivity
0 : Low
1: medium
2: High
3: Lower
4: Lowest
valid
Whether the area is valid
0:invalid
1:valid