Foscam CGI - Setportinfo; Getupnpconfig; Setupnpconfig

Foscam IPCamera CGI User Guide
Copyright@ Shenzhen Foscam Intelligent Technology Limited
67
onvifPort
Onvif Port(default value is 888)
Note
.You can call this CGI command without usr or pwd section
.onvifPort param only for onvif camera, the camra which does not has onvif
function does not have this param
Example
/cgi-bin/CGIProxy.fcgi?cmd=getPortInfo&usr=admin&pwd=
setPortInfo
Function
Set ports of camera
privilege
admin
Usage
/cgi-bin/CGIProxy.fcgi?cmd=getPortInfo
Param
webPort
http port(default value is 88)
mediaPort
media port(default value is 88)
httpsPort
https port(default value is 443)
onvifPort
Onvif Port(default value is 888)
Return
None
Note
.Re login is needed after call this CGI command
.
onvifPort param only for onvif camera, the camra which does not has onvif
function does not have this param
Example
/cgi-bin/CGIProxy.fcgi?cmd=setPortInfo&webPort=88&mediaPort=88&httpsPo
rt=443&onvifPort=888&usr=admin&pwd=
getUPnPConfig
Function
Get UpnP config
privilege
admin
Usage
/cgi-bin/CGIProxy.fcgi?cmd=getUPnPConfig
Param
None
Return
isEnable
is Enable UpnP function
Note
Example
/cgi-bin/CGIProxy.fcgi?cmd=getUPnPConfig&usr=admin&pwd=
setUPnPConfig
Function
Set UpnP config
privilege
admin
Usage
/cgi-bin/CGIProxy.fcgi?cmd=setUPnPConfig