Foscam CGI - Setsubvideostreamparam; Getmotiondetectconfig1

Foscam IPCamera CGI User Guide
Copyright@ Shenzhen Foscam Intelligent Technology Limited
126
Param
None
Return
resolutionN
Resolution of stream type N
bitRateN
Bit rate of stream type N (20480~2097152)
frameRateN
Frame rate of stream type N
GOPN
P frames between I frame of stream type N
isVBRN
Bitrate control modeof stream type N:0-CBR 1-CBR
2-LBR
lbrRatio
Ratio of LBR,range from 10 to 50
Note
N means streamType [0~3]
Example
/cgi-bin/CGIProxy.fcgi?cmd=getSubVideoStreamParam&usr=admin&pwd=
setSubVideoStreamParam
Function
Set the sub video stream param of stream N
privilege
admin
Usage
/cgi-bin/CGIProxy.fcgi?cmd=setSubVideoStreamParam
Param
streamType
0~3
resolution
Resolution of stream type N
bitRate
Bit rate of stream type N (20480~2097152)
frameRate
Frame rate of stream type N
GOP
P frames between I frame of stream type N
The suggest value is: X * frameRate
isVBR
Bitrate control mode:0-CBR 1-CBR 2-LBR
lbrRatio
Ratio of LBR,range from 10 to 50
Return
None
Note
Example
/cgi-bin/CGIProxy.fcgi?cmd=setSubVideoStreamParam&streamType=0&resoluti
on=0&bitRate=2097152&frameRate=30&GOP=30&isVBR=2&lbrRatio=27&usr=
admin&pwd=
getMotionDetectConfig1
Function
Get motion detect config
privilege
admin
Usage
/cgi-bin/CGIProxy.fcgi?cmd=getMotionDetectConfig
Param
None
Return
isEnable
Is enable motion detect alarm