Fox Thermal FT3 - Page 11

FLOW PARAMETER 2
CAL SPC PRM EXIT
Volt1 = 0.2479
CHG PRV NXT EXIT
Flo1 = 0.0
CHG PRV NXT EXIT
Volt20 = 1.2479
CHG PRV NXT EXIT
Flo20 = 7046.5
CHG PRV NXT EXIT
K fact = 0%
CHG OK
RESTORE DATABASE?
YES NO
RESET CRC?
YES NO
12.5 SCFM
CHG OK
A2=0.0233
CHG OK
Filter=0.8
CHG OK
HiFloAlm=0 SCFM
CHG OK
LoFloAlm=0 SCFM
CHG OK
HiTempAlm=0 °F
CHG OK
LoTempAlm=0 °F
CHG OK
Level 2
password
Level 2
Calibraon Table
Parameters
Flow cuto in selected unit
Pipe Area in m
2
or 
2
Flow Expoal Filter
High Flow Alarm in selected
unit
Low Flow Alarm in selected
unit
High Temperature Alarm in
selected unit
Low Temperature Alarm in
selected unit
velocity in Meter/
hour for point #1
sensor voltage
for point #1
CAL TABLE
TB1 (TB2) (TB3) EXIT
Cycle through
up to 20 sengs
Level 1
NOTE! Some menus will only be available with a level 2 password.
Model FT3
Introduction | 11
Introduction
Fig. 1.4: FT3 Menu Tree - Flow Parameter 2