Frick QUANTUM LX - ANALOG BOARD VALUES: (READ ONLY)

S90-020 M FRICK
®
QUANTUM™ LX COMPRESSOR CONTROL PANEL
Page 52 MAINTENANCE
SETPOINTS (Continued)
Compressor Safeties Setpoints
Setpoint
Load Inhibit
Force Unload
Warning
Warning Delay
Shutdown
High Discharge
Temperature
Shutdown Delay
Starting Differential Pressure Below ___________
Load Inhibit
Force Unload
Warning
Warning Delay
Shutdown
Shutdown Delay
Highest Capacity To Permit Starting
Starting Period Before Permitting Capacity Increase
Stopping Period for Capacity Unload
High Discharge
Pressure
Compressor Automatic Mode Minimum Capacity
Disabled Enabled
Capacity
Unload Assist
 
Setpoint
Load Inhibit
Force Unload
Warning
Warning Delay
Shutdown
High Suction
Pressure
Shutdown Delay
Pressure Input
Disabled Enabled
On when
above
Off when
below
Override:
Discharge
Pressure <
(suction x 1.6^k)
Disabled Enabled
Port Value
Economizer
   
Disabled Enabled On Off Ignore Delay Fail Delay
Balance Piston
 
Disabled Enabled Delay
Oil Log
 
On When Discharge Temperature
Disabled Enabled
Is Above For
Main Oil
Injection
 