Dear customer,
Congratulations on choosing a quality product from FRÖLING.
The FRÖLING P4 Pellet features a state-of-the-art design that conforms
to all currently applicable standards and testing guidelines.
Please read and observe the operating instructions and always keep
them close to the boiler for reference. They contain safety information
and all the operation and maintenance specifications needed to operate
the boiler safely, properly and economically.
The constant further development of our products means that there may
be minor differences from the pictures and content. If you discover any
errors, please let us know.
Subject to technical change.
The P4 Pellet boiler is produced using the highest quality materials and
modern production system. The use of high technology laser cutting and
robotic welding system, accompanied by time honoured European
design, craftsmanship and attention to detail, results in a long lasting
boiler with unmatched fit and finish.
With proper installation, operation and maintenance your P4 pellet boiler
will provide years of safe, dependable, economic and earth friendly
heating.
This manual contains paragraphs that require your special attention.
These paragraphs are marked with the safety information according to
ANSI Z535 described in chapter 2.
Units of Measurement
Most hardware and fittings on the boiler are metric (some plumbing
fittings are British Straight Thread). In this manual the convention used
for dimensions is that values are presented in English units, followed by
metric units in parenthesis, for example: 6” (152 mm).
In this manual temperatures are presented as degrees Centigrade.
Note: A conversion table between Centigrade and Fahrenheit is provided
in Section 7.2.
Installation and Warranty Requirements
This product is provided with a limited warranty which is described in
Section 7.1 within this manual. The warranty is contingent upon the
successful and legal installation of the boiler. At a minimum, the
installation, adjustment, start up, service, and maintenance of this
product must be performed by a licensed professional heating system
installer. Where applicable, the installation must be inspected and
accepted by the legally responsible entity. Conditions described in the
text of the warranty for keeping it in force must be followed by the
owner/ system operator.
If the boiler has been purchased through a dealer, the warranty claim
must be made to the dealer. Otherwise, claims may be made directly to
Tarm Biomass.
Please read the literature enclosed by the manufacturer regarding the
various accessory devices. These devices are warranted by the
manufacturer, NOT BY Tarm Biomass. These accessory devices must be
To Next Page
Loading...
Need help?
General
