About This Manual
wireless at the speed of light …………….
3
-Series Installation Manual
Product Labeling
The SONAbeam terminal is labeled with the following symbols:
WARNING: Electrical Hazard –
Dangerous high voltage is present
inside that could result in injury or
death to personnel…
CAUTION: Damage to the equipment
or Injury to the operator may occur
if procedures are not followed…
ATTENTION: Read the Installation
Manual before attempting to install
the equipment!
USE THE STRAIN RELIEF to secure
your terminal cabling!
IEC60825-1 Classification
Label – Class 1M laser
Product…
NOTE: The Alignment Telescope – provided as part of the SONAbeam Basic
Alignment Kit – has a special spectral filter installed to make it safe to use with
SONAbeam products.
To Next Page
Loading...