Preparing Your Installation Site
14
wireless at the speed of light …………….
NAbeam E-Series Installation Manual
Pedestal Mount
The optional Pedestal Mount is designed for
mounting a SONAbeam terminal approximately
600mm (2ft) above any level, hard, flat and stable
surface.
With suitable anchors for the base surface, the bolt-
on Pedestal Mount offers economical rapid
deployment of a versatile terminal platform.
Customer Fabricated Mount
The elegance of the E-Series terminal’s integrated mounting plate makes it possible for
you to easily fabricate your own mounting platform for an E-Series SONAbeam terminal
using the following information:
Mounting surface must be FLAT and relatively level…
Mounting Stud can be alternatively fabricated with M12 thread provided
installer provides matching M12 nut to replace the ½”-13 UNC nut provided
with your terminal.
WARNING!
When constructing your mount on rooftops, ensure it has a solid ground
connection. A 6AWG insulated, stranded ground wire, no longer than 25’ in
length is recommended.
surfaces are likewise
effective…
surface: 180mm (7”)
thickness: 6mm (1/4”)
½”-13 UNC (or M12)
¾” (
19mm
) above base
Steel
w/suitable finish
225mm (9”)
To Next Page
Loading...