Installing Your SONAbeam Terminal
wireless at the speed of light …………….
29
-Series Installation Manual
Installing Your
SONAbeam Terminal
The physical installation of SONAbeam terminals is a simple and straightforward
procedure when conducted by qualified personnel in accordance with the procedures
described in this manual.
This section provides the following step-by-step procedures:
Installing the Mounting Assembly…
Installing the optical head Assembly…
Interfacing the optical head and your Customer Interface Box…
WARNING!
The installation and wiring of SONAbeam terminals must be performed by
qualified equipment installers…
Safety First, Safety Always
The installation of the SONAbeam terminal can expose personnel to potential trip
hazards, fall hazards and lifting hazards. TAKE EVERY PRECAUTION TO ENSURE
THE SAFETY OF EVERYONE INVOLVED IN YOUR INSTALLATION EFFORTS!
Before You Begin…
Before you begin to install a SONAbeam terminal, your installation plan should have the
following items completed at BOTH installation sites:
A properly installed and grounded Mounting Mast...
All necessary power and network interfaces run to the installation site and
properly terminated in your Customer Interface Box…
WARNING!
All cabling to the Customer Interface Box must be run in suitably rated conduit…
To Next Page
Loading...