17
Local/remote operation setting (Setting range: LoCL/rEM) (Option)
[Description]
•This parameter is used to switch between local and re-
mote operations.
[Setting example] Switching to remote operation
Press and hold the
SEL
key for one second.
will be displayed on the PV display section.
Press the keys to display .
Press the
SEL
key once.
The current setting (
) in the SV display section flickers.
Press the keys to display .
Press the
SEL
key once. Flickering stops and the operation is switched to remote.
To display the operation status, press and hold the
SEL
key for two seconds.
Operating procedureDisplay
1.
2.
4.
6.
Set value Operation
Performs local operation.
Performs remote operation.
(“ ” and the set value (SV) are displayed
alternately in the SV display section on the
front face while in remote operation.)
Related parameters:
(page 75)
(page 75)
(page 76)
(page 77)
* Local operation: Control by SV set by the keys on the
front face, ramp-soak operation, SV
selection determined by digital input,
and SV setting via communication
* Remote operation: Control by SV determined by Remote
SV input
3.
5.
To Next Page
Loading...
Need help?
General
