35
PV (Measured value) stable range (Setting range: 0 to 100%FS)
[Description]
• Self-tuning logic recognizes that control is stable if PV is
staying within the SV ± .
[Setting example] Changing the PV stable range from 2 to 3
Press and hold the
SEL
key for three seconds.
will be displayed on the PV display.
Press the key to display .
Press the
SEL
key once.
The current setting ( ) flashes on the SV display.
Press the
or
keys to display .
Press the
SEL
key once. will stop flashing and will be registered for . After that, the
controller will operate with the PV range being 3.
If you want to display the operation status, press and hold the
SEL
key for two seconds.
Operating procedureDisplay
1.
2.
3.
4.
5.
6.
• It is not necessary to set this parameter under normal con-
ditions.
To Next Page
Loading...
Need help?
General
