Fuji Electric Micro-controller X Series User Manual

42
[Description]
• This parameter is used for selecting the number of decimal
point positions for the PV (Measured value).
Decimal point position (Settings: 0 / 1 / 2)
Related parameters: (page 40)
(page 40)
[Setting example] Changing the decimal point position setting from 0 to 1
Press and hold the
SEL
key for three seconds.
will be displayed on the PV display.
Press the key to display .
Press the
SEL
key once.
The current setting ( ) flashes on the SV display.
Press the
key to display .
Press the
SEL
key once. will stop flashing and will be registered for . After that, the
controller will operate with one decimal point position displayed.
If you want to display the operation status, press and hold the
SEL
key for two seconds.
Operating procedureDisplay
1.
2.
3.
4.
5.
6.
“0” (No digit after decimal point)
“1” (1 digit after decimal point)
“2” (2 digit after decimal point. This is valid only for the voltage and current inputs)

Fuji Electric Micro-controller X Series Specifications

General

Brand	Fuji Electric
Model	Micro-controller X Series
Category	Microcontrollers
Language	English