41
[Setting example] Changing the measuring range from 0°C to 150°C to
-
100°C to 200°C (Pt100)
Press and hold the
SEL
key for three seconds.
will be displayed on the PV display.
Press the
key to display .
Press the
SEL
key once.
The current setting ( ) flashes on the SV display.
Press the or key to display .
Press the
SEL
key once. will stop flashing and will be registered for .
Press the
key to display on the PV display.
Press the
SEL
key once.
The current setting ( ) flashes on the SV display.
Press the
or
key to display .
Press the
SEL
key once. will be registered for . After that, the controller will operate
with the measured range being
-
100°C to 200°C.
If you want to display the operation status, press and hold the
SEL
key for two seconds.
Operating procedureDisplay
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.