70
[Description]
• Do not set the same number as other Micro-controllers.
• See Communication function instruction manual for details.
Station No. for communication (Setting range: 0 to 255)
[Setting example] Setting the station No. to “123”
Press and hold the
SEL
key for five seconds.
will be displayed on the PV display.
Press the
key to display
.
Press the
SEL
key once.
The current setting (
) flashes on the SV display.
Press the
or
keys to display
.
Press the
SEL
key once. will stop flashing and will be registered for . After that, the
controller will operate with the station number being 123.
If you want to display the operation status, press and hold the
SEL
key for two seconds.
Operating procedureDisplay
1.
2.
3.
4.
5.
6.
[Note]
• In the case of Modbus (RTU) communication specifications, communication is prohibited if the station No. is set to 0.
• In the case of Z-ASCII communication specifications, communication is allowed even if the station No. is set to 0.
To Next Page
Loading...
Need help?
General
