Fuji Electric Micro-controller X Series - Page 61

61
[Setting example] Setting the error status alarm function for Alarm 2 to ON
Press and hold the
SEL
key for five seconds.
will be displayed on the PV display.
Press the key to display .
Press the
SEL
key once.
The current setting ( ) flashes on the SV display.
Press the or keys to display .
Press the
SEL
key once. will stop flashing and will be registered for . After that, the
controller will operate with the error status alarm function for Alarm 2 being ON.
If you want to display the operation status, press and hold the
SEL
key for two seconds.
Operating procedureDisplay
1.
2.
3.
4.
5.
6.