5-6 5. KEYENCE
5.1.4 KV-700
Communication Setting
Editor
Communication setting
(Underlined setting: default)
PLC
KV-700 (CPU Modular Port)
No particular setting is necessary on the PLC.
KV-L20
Unit editor setting
* These settings can be checked on the access window of the CPU. For more information, refer to the PLC manual issued by the manufacturer.
KV-L20R
Unit editor setting
* These settings can be checked on the access window of the CPU. For more information, refer to the PLC manual issued by the manufacturer.
Item Setting Remarks
Connection Mode 1:1
/ Multi-link2 / Multi-link2 (Ethernet)
Signal Level RS-232C
/ RS-422/485
Baud Rate 9600 / 19200 / 38400 / 57600
bps
Data Length 8 bits
Stop Bit 1 bit
Parity Even
Targe t Port No. 0
to 31
Port Item Setting Remarks
Port 1
Operation Mode KV BUILDER Mode
RS/CS Flow Control No
Port 2
Operation Mode KV BUILDER Mode
Interface RS-232C / RS-422A
Change the setting using the PORT 2
selector switch attached to the side.
Station No. 0 to 9
Port Item Setting Remarks
Basic Port Station No. 0 to 9 Common to Port 1 and 2.
Port 1
Operation Mode KV BUILDER/KV STUDIO Mode
RS/CS Flow Control No
Port 2
Operation Mode KV BUILDER/KV STUDIO Mode
Interface
RS-232C/RS-422A/485 (4-wire
system)
PORT 2 selector switch attached to
the side
PORT2
232C 422A VT
To Next Page
Loading...