9.1 PLC Connection 9-41
PLC
FX3U-ENET-L
Make PLC settings using the configuration tool “FX3U-ENET-L”.
Ethernet operational settings
Ethernet open settings
Use row No. 3 or No. 4 for setting.
FX3U-ENET
Make the PLC setting using the programming tool “FX-Configurator-EN”. For more information, refer to the PLC manual
issued by the manufacturer.
Ethernet operational settings
Item Setting Remarks
Communication data code Binary code
Initial timing
Always wait for OPEN (Communication possible
at STOP time)
IP address (DEC) Specify according to the environment.
Item Setting Remarks
Protocol UDP
Open system MC protocol
Existence confirmation No confirm
Host station Port No. (DEC) As desired 1025 to 5548, 5552 to 65534
Transmission target device IP
address
IP address of the V9
Transmission target device Port
No. (DEC)
Port number of the V9
Item Setting Remarks
Communication data code Binary code
Initial timing
Always wait for OPEN
(Communication possible at STOP time)
IP address (DEC)
Make settings in accordance with the
network environment.
To Next Page
Loading...