9-60 9. MITSUBISHI ELECTRIC
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
D (Parameter)
* These memory addresses are not available for FR-S500
Device Memory TYPE Remarks
P (parameter) 00H Refer to the list file or the parameter list for the inverter.
D (parameter) 01H Refer to the table below.
Address Name
D0 Operation mode
When issuing a command, such as a run command, from the V series, select
“Communication and Run”.
FR-E500 : 0002 H
FR-A500 : 0002 H
FR-F500 : 0002 H
FR-S500 : 0000 H
D1 Output frequency (Rotation)
D2 Output current
D3 Output voltage
D4
Alarm contents (last / most recent)
D5 Alarm contents (three times before / two times before)
D6
Alarm contents (five times before / four times before)
*
D7
Alarm contents (seven times before / six times before)
*
D8
Inverter status monitor
D9 Changeover to second parameter
When setting device memory:
By default, only the “List” file of “FR-E500” can be browsed by pressing the [Refer] button.
If an inverter such as “A500”, “F500”, or “S500” is used, refer to the parameter list described in each
inverter’s manual and then set the device memory.
Data Contents Data Contents Data Contents Data Contents
H00 none H22 OV3 H80 GF HB2 RET
H10 OC1 H30 THT H81 LF HC2 P24
H11 OC2 H31 THM H90 OHT HF3 E.3
H12 OC3 H40 FIN HA0 OPT HF6 E.6
H20 OV1 H60 OLT HB0 PE HF7 E.7
H21 OV2 H70 BE HB1 PUE
To Next Page
Loading...