9-70 9. MITSUBISHI ELECTRIC
Set the target device memory on the [Device Input] dialog.
RAM: Stored in RAM
EEPROM: Stored in RAM + EEPROM
Indirect Device Memory Designation
Address No. 0 to 65535
* Expansion code
06A (basic setting parameters upper limit) 1EH Double-word, read only
06B (gain/filter parameters upper limit) 1FH Double-word, read only
06C (extension setting parameters upper limit) 20H Double-word, read only
06D (I/O setting parameters upper limit) 21H Double-word, read only
F06A (basic setting parameters upper limit) 22H Real number, read only
F06B (gain/filter parameters upper limit) 23H Real number, read only
F06C (extension setting parameters upper limit) 24H Real number, read only
F06D (I/O setting parameters upper limit) 25H Real number, read only
07A (basic setting parameters lower limit) 1EH Double-word, read only
07B (gain/filter parameters lower limit) 1FH Double-word, read only
07C (extension setting parameters lower limit) 20H Double-word, read only
07D (I/O setting parameters lower limit) 21H Double-word, read only
F07A (basic setting parameters lower limit) 22H Real number, read only
F07B (gain/filter parameters lower limit) 23H Real number, read only
F07C (extension setting parameters lower limit) 24H Real number, read only
F07D (I/O setting parameters lower limit) 25H Real number, read only
S08A (basic setting parameters symbol) 2EH Read only
S08B (gain/filter parameters symbol) 2FH Read only
S08C (extension setting parameters symbol) 30H Read only
S08D (I/O setting parameters symbol) 31H Read only
09A (write enable/disable of basic setting parameters) 32H Read only
09B (write enable/disable of gain/filter parameters) 33H Read only
09C
(write enable/disable of extension setting
parameters)
34H Read only
09D (write enable/disable of I/O setting parameters) 35H Read only
F40 (point table Point data) 36H Real number
50 (point table Servo motor speed) 37H Double-word
54 (point table Acceleration time constant) 38H Double-word
58 (point table Deceleration time constant) 39H Double-word
60 (point table Dwell) 3AH Double-word
64 (point table Auxiliary function) 3BH Double-word
45 (point table M code) 3CH Double-word
Device Memory TYPE Remarks
15 8 7 0
n+0
Models Device Type
n+1
Address No.
n+2
Expansion code * Bit designation
n+3
00 Station number
15 8
000000
Expansion bits
0: 0 to 15 bits
1: 16 to 31 bits
0: RAM
1: RAM+EEPROM
To Next Page
Loading...