Fuji Electric Monitouch V9 Series - Page 364

15.1 PLC Connection 15-3
15.1.1 FP Series (RS232C/422)
Communication Setting
Editor
Communication setting
(Underlined setting: default)
PLC
Be sure to match the settings to those made under [Communication Setting] of the editor.
FP-X
Tool port setting
(Underlined setting: default)
*1 System register setting is enabled in the RUN mode.
COM port setting
(Underlined setting: default)
*1 System register setting is enabled in the RUN mode.
*2 For AFPX COM3, set the switch attached to the back of the cassette as well.
SW1 to 3: ON (RS-485), SW4: ON (terminator ON)
*3 Some restrictions may apply to the communication cassette when the USB port is used on the CPU. For more information, refer to the
PLC manual issued by the manufacturer.
Item Setting Remarks
Connection Mode
1:1
/ 1:n / Multi-link / Multi-link2 /
Multi-link2 (Ethernet) / 1:n Multi-link2 (Ethernet)
Signal Level RS-232C
/ RS-422/485
Baud Rate 4800 / 9600 / 19200
/ 38400 /57600 / 115k bps
Data Length 7 / 8
bits
Stop Bit 1
/ 2 bits
Parity None / Odd
/ Even
Target Port No. 0 to 31
Header % (Header)
/ < (Extension Header)
Models on which “< (Extension header)” is available:
FP2, FP2SH, FP, FP-X, FP0R
Monitor Registration Unchecked / Checked
One V9 unit can be registered as a monitor for one
PLC. When multi-link connection (n : 1) is selected, do
not check this box for multiple V9 units.
System Register
*1
Contents
410 Unit No. 1
to 99
412 Communication Mode Computer link
413
Data Length 7 / 8
bits
Parity None / Odd
/ Even
Stop Bit 1
/ 2 bits
415 Baud Rate 4800 / 9600
/ 19200 / 38400 /57600 / 115k bps
System Register
*1
Contents
COM1 COM2
410 411 Unit No. 1
to 99
412 Operation Mode Computer link
413 414
Data Length 7 / 8
bits
Parity None / Odd
/ Even
Stop Bit 1
/ 2 bits
415 Baud Rate
4800 / 9600
/ 19200 / 38400 /57600 / 115k bps
*2